ECS4100 Series CLI Reference Guide-R07

Chapter 24 | ERPS Commands
– 632 –
Command Usage
◆ Two steps are required to make a ring operating in non-revertive mode return
to Idle state from forced switch or manual switch state:
1.Issue an erps clear command to remove the forced switch command on the
node where a local forced switch command is active.
2.Issue an erps clear command on the RPL owner node to trigger the
reversion.
◆ The erps clear command will also stop the WTR and WTB delay timers and
reset their values.
◆ More detailed information about using this command for non-revertive mode
is included under the Command Usage section for the non-revertive command.
Example
Console#erps clear instance r&d
Console#
clear erps statistics This command clears all statistics for a specific ERPS instance, or all instances.
Syntax
clear erps statistics [instance instance-name]
instance-name - Name of a specific ERPS instance. (Range: 1-12 characters)
Command Mode
Privileged Exec
Example
Console#clear erps statistics instance r&d
Console#
show erps statistics This command displays statistics information for all configured instances, or for a
specified instance.
Syntax
show erps statistics [instance instance-name]]
instance-name - Name of a specific ERPS instance. (Range: 1-12 characters)
Command Mode
Privileged Exec