ECS4100 Series CLI Reference Guide-R07

Chapter 23 | VLAN Commands
Configuring VLAN Interfaces
– 563 –
◆ If a VLAN on the forbidden list for an interface is manually added to that
interface, the VLAN is automatically removed from the forbidden list for that
interface.
◆ Ports can only be added to an RSPAN VLAN using the commands described
under “RSPAN Mirroring Commands”.
Example
The following example shows how to add VLANs 1, 2, 5 and 6 to the allowed list as
tagged VLANs for port 1:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport allowed vlan add 1,2,5,6 tagged
Console(config-if)#
switchport
ingress-filtering
This command enables ingress filtering for an interface. Use the no form to restore
the default.
Syntax
[no] switchport ingress-filtering
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
◆ Ingress filtering only affects tagged frames.
◆ If ingress filtering is disabled and a port receives frames tagged for VLANs for
which it is not a member, these frames will be flooded to all other ports (except
for those VLANs explicitly forbidden on this port).
◆ If ingress filtering is enabled and a port receives frames tagged for VLANs for
which it is not a member, these frames will be discarded.
◆ Ingress filtering does not affect VLAN independent BPDU frames, such as GVRP
or STA. However, they do affect VLAN dependent BPDU frames, such as GMRP.