ECS4100 Series CLI Reference Guide-R07

Chapter 13 | Power over Ethernet Commands
– 454 –
Example
Console(config)#led-port-mode poe
Console(config)#
show power inline
status
This command displays the current power status for all ports or for specific ports.
Syntax
show power inline status [interface]
interface
ethernet
unit - Unit identifier. (Range: 1)
port - Port number. (Ethernet ports 1-8, 24, 48)
Command Mode
Privileged Exec
Example
Console#show power inline status
Unit: 1
Compatible Mode : Enabled
Time Max Used
Interface Admin Range Oper Class Power Power Priority
--------- -------- -------- ---- ----- -------- -------- --------
Eth 1/ 1 Enabled -- Off - 3360 mW 0 mW Low
Eth 1/ 2 Enabled -- Off - 33600 mW 0 mW Low
Eth 1/ 3 Enabled -- Off - 33600 mW 0 mW Low
Eth 1/ 4 Enabled -- Off - 33600 mW 0 mW Low
Eth 1/ 5 Enabled -- Off - 33600 mW 0 mW Low
Eth 1/ 6 Enabled -- Off - 33600 mW 0 mW Low
Eth 1/ 7 Enabled -- Off - 33600 mW 0 mW Low
Eth 1/ 8 Enabled -- Off - 33600 mW 0 mW Low
Console#
Table 86: show power inline status - display description
Field Description
Compatible Mode Shows if the switch detects and provides power to powered devices that were
designed prior to the IEEE 802.3af PoE standard (see power inline compatible)
Interface The PoE port
Admin The administrative power mode set on the port (see power inline)
Time Range The time range during which power is supplied (see time-range)
Oper The current operating power status (displays on or off). Note that if power is
turned off due to an overload, administative status will still display enabled.
Class Shows the maximum power allocation class if defined by the global
configuration command power mainpower maximum allocation. Class
information is shown only when Oper = On.