ECS4100 Series CLI Reference Guide-R07

Chapter 8 | Authentication Commands
PPPoE Intermediate Agent
– 288 –
Example
Console(config)#pppoe intermediate-agent format-type access-node-identifier
billibong
Console(config)#
pppoe intermediate-
agent port-enable
This command enables the PPPoE IA on an interface. Use the no form to disable this
feature.
Syntax
[no] pppoe intermediate-agent port-enable
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
PPPoE IA must also be enabled globally on the switch for this command to take
effect.
Example
Console(config)#interface ethernet 1/5
Console(config-if)#pppoe intermediate-agent port-enable
Console(config-if)#
pppoe intermediate-
agent port-format-
type
This command sets the circuit-id, remote-id, or remote-id delimiter for an interface.
Use the no form to restore the default settings.
Syntax
pppoe intermediate-agent port-format-type
{carry-to-client |
circuit-id [string | hostname-port-vlan] circuit-id-string |
remote-id {mac-cpe | string remote-id-string} |
remote-id-delimiter {enable | ascii-code}}
no pppoe intermediate-agent port-format-type {carry-to-client | circuit-id
| remote-id | remote-id-delimiter enable}
carry-to-client - Carries circuit ID/remote ID to the client.
circuit-id-string - String identifying the circuit identifier (or interface) on this
switch to which the user is connected. (Range: 1-57 ASCII characters)
circuit-id hostname-port-vlan - Specifies circuit ID format hostname/port/
vlan