ECS4100 Series CLI Reference Guide-R07

Chapter 5 | SNMP Commands
SNMP Target Host Commands
– 199 –
Command Usage
This command can enable MAC authentication traps on the current interface only if
they are also enabled at the global level with the snmp-server enable traps mac-
authentication command.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps mac-notification
Console(config)#
show snmp-server
enable port-traps
This command shows if SNMP traps are enabled or disabled for the specified
interfaces.
Syntax
show snmp-server enable port-traps interface [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12/26/28/52)
port-channel channel-id (Range: 1-16)
Command Mode
Privileged Exec
Example
Console#show snmp-server enable port-traps interface
Interface MAC Notification Trap
--------- ---------------------
Eth 1/1 No
Eth 1/2 No
Eth 1/3 No
.
.
.