ECS3510-28T_Management Guide-R05

C HAPTER 38 | Multicast Filtering Commands
MVR for IPv4
– 1248 –
COMMAND MODE
Global Configuration
EXAMPLE
The following an MVR group address profile to domain 1:
Console(config)#mvr domain 1 associated-profile rd
Console(config)#
RELATED COMMANDS
mvr profile (1249)
mvr domain This command enables Multicast VLAN Registration (MVR) for a specific
domain. Use the no form of this command to disable MVR for a domain.
SYNTAX
[no] mvr domain domain-id
domain-id - An independent multicast domain. (Range: 1-5)
DEFAULT SETTING
Disabled
COMMAND MODE
Global Configuration
COMMAND USAGE
Only IGMP version 2 or 3 hosts can issue multicast join or leave messages.
If MVR must be configured for an IGMP version 1 host, the multicast
groups must be statically assigned using the mvr vlan group command.
EXAMPLE
The following example enables MVR for domain 1:
Console(config)#mvr domain 1
Console(config)#
mvr priority This command assigns a priority to all multicast traffic in the MVR VLAN.
Use the no form of this command to restore the default setting.
SYNTAX
mvr priority priority
no mvr priority
priority - The CoS priority assigned to all multicast traffic forwarded
into the MVR VLAN. (Range: 0-7, where 7 is the highest priority)