ECS3510-28T_Management Guide-R05

C HAPTER 38 | Multicast Filtering Commands
MLD Snooping
– 1233 –
Console(config)#interface vlan 1
Console(config-if)#ipv6 mld snooping immediate-leave
Console(config-if)#
ipv6 mld snooping
vlan mrouter
This command statically configures an IPv6 multicast router port. Use the
no form to remove the configuration.
SYNTAX
[no] ipv6 mld snooping vlan vlan-id mrouter interface
vlan-id - VLAN ID (Range: 1-4094)
interface
ethernet unit/port
unit - Stack unit. (Range: 1)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-16)
DEFAULT SETTING
No static multicast router ports are configured.
COMMAND MODE
Global Configuration
COMMAND USAGE
Depending on your network connections, MLD snooping may not always be
able to locate the MLD querier. Therefore, if the MLD querier is a known
multicast router/switch connected over the network to an interface (port or
trunk) on the switch, you can manually configure that interface to join all
the current multicast groups.
EXAMPLE
The following shows how to configure port 1 as a multicast router port within
VLAN 1:
Console(config)#ipv6 mld snooping vlan 1 mrouter ethernet 1/1
Console(config)#
ipv6 mld snooping
vlan static
This command adds a port to an IPv6 multicast group. Use the no form to
remove the port.
SYNTAX
[no] ipv6 mld snooping vlan vlan-id static ipv6-address interface
vlan - VLAN ID (Range: 1-4094)