ECS3510-26P_Management Guide R02

C HAPTER 3 | Using the Web Interface
Navigating the Web Browser Interface
– 84 –
MAIN MENU Using the onboard web agent, you can define system parameters, manage
and control the switch, and all its ports, or monitor network conditions. The
following table briefly describes the selections available from this program.
Table 6: Switch Main Menu
Menu Description Page
System
General Provides basic system description, including contact information 97
Switch Shows the number of ports, hardware version, power status, and
firmware version numbers
98
IP Sets the IPv4 address for management access 443
Capability Enables support for jumbo frames;
shows the bridge extension parameters
100,
101
File 102
Copy Allows the transfer and copying files 102
Set Startup Sets the startup file 105
Show Shows the files stored in flash memory; allows deletion of files 106
Automatic Operation Code Upgrade Automatically upgrades operation code if a newer version is
found on the server
107
Time 111
Configure General
Manual Manually sets the current time 111
SNTP Configures SNTP polling interval 112
Configure Time Server Configures a list of SNTP servers 113
Configure Time Zone Sets the local time zone for the system clock 114
Configure Summer Time Configures summer time settings 115
Console Sets console port connection parameters 117
Telnet Sets Telnet connection parameters 119
CPU Utilization Displays information on CPU utilization 120
Memory Status Shows memory utilization parameters 121
Reload Restarts the switch immediately, at a specified time, after a
specified delay, or at a periodic interval
122
Interface 127
Port 127
General
Configure by Port List Configures connection settings per port 127
Configure by Port Range Configures connection settings for a range of ports 130
Show Information Displays port connection status 131
Mirror 132
Add Sets the source and target ports for mirroring 132
Show Shows the configured mirror sessions 132