ECS3510-26P_Management Guide R02

C HAPTER 33 | VLAN Commands
Configuring VLAN Interfaces
– 833 –
the port’s default VLAN (i.e., associated with the PVID) are also
transmitted as tagged frames.
DEFAULT SETTING
Access mode, with the PVID set to VLAN 1.
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
COMMAND USAGE
Access mode is mutually exclusive with VLAN trunking (see the vlan-
trunking command). If VLAN trunking is enabled on an interface, then that
interface cannot be set to access mode, and vice versa.
EXAMPLE
The following shows how to set the configuration mode to port 1, and then
set the switchport mode to hybrid:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport mode hybrid
Console(config-if)#
RELATED COMMANDS
switchport acceptable-frame-types (830)
switchport native
vlan
This command configures the PVID (i.e., default VLAN ID) for a port. Use
the no form to restore the default.
SYNTAX
switchport native vlan vlan-id
no switchport native vlan
vlan-id - Default VLAN ID for a port. (Range: 1-4093)
DEFAULT SETTING
VLAN 1
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
COMMAND USAGE
◆ When using Access mode, and an interface is assigned to a new VLAN,
its PVID is automatically set to the identifier for that VLAN. When using
Hybrid mode, the PVID for an interface can be set to any VLAN for
which it is an untagged member.
◆ If acceptable frame types is set to all or switchport mode is set to
hybrid, the PVID will be inserted into all untagged frames entering the
ingress port.