ECS3510-26P_Management Guide R02

C HAPTER 17 | Multicast Filtering
Multicast VLAN Registration
– 499 –
◆ Only IGMP version 2 or 3 hosts can issue multicast join or leave
messages. If MVR must be configured for an IGMP version 1 host, the
multicast groups must be statically assigned.
◆ The MVR VLAN cannot be specified as the receiver VLAN for static
bindings.
PARAMETERS
These parameters are displayed:
◆ Port – Port identifier.
◆ VLAN – VLAN identifier. (Range: 1-4093)
◆ Group IP Address – Defines a multicast service sent to the selected
port. Multicast groups must be assigned from the MVR group range
configured on the Configure General page.
WEB INTERFACE
To assign a static MVR group to a port:
1. Click Multicast, MVR.
2. Select Configure Static Group Member from the Step list.
3. Select Add from the Action list.
4. Select a VLAN and port member to receive the multicast stream, and
then enter the multicast group address.
5. Click Apply.
Figure 302: Assigning Static MVR Groups to a Port
To show the static MVR groups assigned to a port:
1. Click Multicast, MVR.
2. Select Configure Static Group Member from the Step list.
3. Select Show from the Action list.