ECS3510-26P_Management Guide R02

C HAPTER 15 | IP Configuration
Setting the Switch’s IP Address (IP Version 6)
– 452 –
■
Link Local – Configures an IPv6 link-local address.
■
The address prefix must be in the range of FE80~FEBF.
■
You can configure only one link-local address per interface.
■
The specified address replaces a link-local address that was
automatically generated for the interface.
◆ IPv6 Address – IPv6 address assigned to this interface.
WEB INTERFACE
To configure an IPv6 address:
1. Click IP, IPv6 Configuration.
2. Select Add IPv6 Address from the Action list.
3. Specify the VLAN to configure, select the address type, and then enter
an IPv6 address and prefix length.
4. Click Apply.
Figure 267: Configuring an IPv6 Address
SHOWING IPV6
A
DDRESSES
Use the IP > IPv6 Configuration (Show IPv6 Address) page to display the
IPv6 addresses assigned to an interface.
CLI REFERENCES
◆ "show ipv6 interface" on page 980
PARAMETERS
These parameters are displayed:
◆ VLAN – ID of a configured VLAN which is to be used for management
access. By default, all ports on the switch are members of VLAN 1.
However, the management station can be attached to a port belonging
to any VLAN, as long as that VLAN has been assigned an IP address.
(Range: 1-4093)
◆ IP Address Type – The address type (Global, EUI-64, Link Local).