ECS3510-26P_Management Guide R02

C HAPTER 15 | IP Configuration
Setting the Switch’s IP Address (IP Version 6)
– 448 –
◆ ND DAD Attempts – The number of consecutive neighbor solicitation
messages sent on an interface during duplicate address detection.
(Range: 0-600, Default: 3)
■
Configuring a value of 0 disables duplicate address detection.
■
Duplicate address detection determines if a new unicast IPv6
address already exists on the network before it is assigned to an
interface.
■
Duplicate address detection is stopped on any interface that has
been suspended (see "Configuring VLAN Groups" on page 170).
While an interface is suspended, all unicast IPv6 addresses assigned
to that interface are placed in a “pending” state. Duplicate address
detection is automatically restarted when the interface is
administratively re-activated.
■
An interface that is re-activated restarts duplicate address detection
for all unicast IPv6 addresses on the interface. While duplicate
address detection is performed on the interface’s link-local address,
the other IPv6 addresses remain in a “tentative” state. If no
duplicate link-local address is found, duplicate address detection is
started for the remaining IPv6 addresses.
■
If a duplicate address is detected, it is set to “duplicate” state, and a
warning message is sent to the console. If a duplicate link-local
address is detected, IPv6 processes are disabled on the interface. If
a duplicate global unicast address is detected, it is not used. All
configuration commands associated with a duplicate address remain
configured while the address is in “duplicate” state.
■
If the link-local address for an interface is changed, duplicate
address detection is performed on the new link-local address, but
not for any of the IPv6 global unicast addresses already associated
with the interface.
◆ ND NS Interval – The interval between transmitting IPv6 neighbor
solicitation messages on an interface. (Range: 1000-3600000
milliseconds;
Default: 1000 milliseconds is used for neighbor discovery operations,
0 milliseconds is advertised in router advertisements.
This attribute specifies the interval between transmitting neighbor
solicitation messages when resolving an address, or when probing the
reachability of a neighbor. Therefore, avoid using very short intervals
for normal IPv6 operations.
◆ Restart DHCPv6 – When DHCPv6 is restarted, the switch may attempt
to acquire an IP address prefix through stateful address
autoconfiguration. If the router advertisements have the “other stateful
configuration” flag set, the switch may also attempt to acquire other
non-address configuration information (such as a default gateway)
when DHCPv6 is restarted.
Prior to submitting a client request to a DHCPv6 server, the switch
should be configured with a link-local address using the Address
Autoconfig option. The state of the Managed Address Configuration flag