ECS3510-26P_Management Guide R02

C HAPTER 14 | Basic Administration Protocols
Link Layer Discovery Protocol
– 390 –
◆ Remote Power Pairs – “Signal” means that the signal pairs only are
in use, and “Spare” means that the spare pairs only are in use.
◆ Remote Power MDI Supported – Shows whether MDI power is
supported on the given port associated with the remote system.
◆ Remote Power Pair Controlable – Indicates whether the pair
selection can be controlled for sourcing power on the given port
associated with the remote system.
◆ Remote Power Classification – This classification is used to tag
different terminals on the Power over LAN network according to their
power consumption. Devices such as IP telephones, WLAN access
points and others, will be classified according to their power
requirements.
Port Details – 802.3 Extension Trunk Information
◆ Remote Link Aggregation Capable – Shows if the remote port is not
in link aggregation state and/or it does not support link aggregation.
◆ Remote Link Aggregation Status – The current aggregation status
of the link.
◆ Remote Link Port ID – This object contains the IEEE 802.3
aggregated port identifier, aAggPortID (IEEE 802.3-2002, 30.7.2.1.1),
derived from the ifNumber of the ifIndex for the port component
associated with the remote system. If the remote port is not in link
aggregation state and/or it does not support link aggregation, this
value should be zero.
Port Details – 802.3 Extension Frame Information
◆ Remote Max Frame Size – An integer value indicating the maximum
supported frame size in octets on the port component associated with
the remote system.
WEB INTERFACE
To display LLDP information for a remote port:
1. Click Administration, LLDP.
2. Select Show Remote Device Information from the Step list.
3. Select Port, Port Details, Trunk, or Trunk Details.