ECS3510-26P_Management Guide R02

C HAPTER 9 | Congestion Control
Automatic Traffic Control
– 234 –
been shut down by a control response, it must be manually re-enabled
using the Manual Control Release (see page 235).
PARAMETERS
These parameters are displayed:
◆ Broadcast Apply Timer – The interval after the upper threshold has
been exceeded at which to apply the control response to broadcast
storms. (Range: 1-300 seconds; Default: 300 seconds)
◆ Broadcast Release Timer – The time at which to release the control
response after ingress traffic has fallen beneath the lower threshold for
broadcast storms. (Range: 1-900 seconds; Default: 900 seconds)
◆ Multicast Apply Timer – The interval after the upper threshold has
been exceeded at which to apply the control response to multicast
storms. (Range: 1-300 seconds; Default: 300 seconds)
◆ Multicast Release Timer – The time at which to release the control
response after ingress traffic has fallen beneath the lower threshold for
multicast storms. (Range: 1-900 seconds; Default: 900 seconds)
WEB INTERFACE
To configure the response timers for automatic storm control:
1. Click Traffic, Congestion Control, Automatic Storm Control.
2. Select Configure Global from the Step field.
3. Set the apply and release timers for broadcast and multicast storms.
4. Click Apply.
Figure 111: Configuring ATC Timers