CLI Reference Guide-R05

Chapter 2 | Using the Command Line Interface
CLI Command Groups
– 77 –
The access mode shown in the following tables is indicated by these abbreviations:
ACL (Access Control List Configuration)
CM (Class Map Configuration)
GC (Global Configuration)
IC (Interface Configuration)
IPC (IGMP Profile Configuration)
LC (Line Configuration)
MST (Multiple Spanning Tree)
NE (Normal Exec)
PE (Privileged Exec)
PM (Policy Map Configuration)
VC (VLAN Database Configuration)
Address Table Configures the address table for filtering specified addresses,
displays current entries, clears the table, or sets the aging time
421
Spanning Tree Configures Spanning Tree settings for the switch 433
VLANs Configures VLAN settings, and defines port membership for
VLAN groups; also enables or configures private VLANs,
protocol VLANs, voice VLANs, and QinQ tunneling
463
Class of Service Sets port priority for untagged frames, selects strict priority or
weighted round robin, relative weight for each priority queue,
also sets priority for DSCP
493
Quality of Service Configures Differentiated Services 505
Multicast Filtering Configures IGMP multicast filtering, query, profile, and proxy
parameters; specifies ports attached to a multicast router; also
configures multicast VLAN registration, and IPv6 MLD
snooping
517
Link Layer Discovery
Protocol
Configures LLDP settings to enable information discovery
about neighbor devices
577
Domain Name Service Configures DNS services. 601
Dynamic Host
Configuration Protocol
Configures DHCP client and relayfunctions 611
IP Interface Configures IP address for the switch interfaces; also
configures ARP parameters
623
IP Routing Configures static and dynamic unicast routing 661
Table 6: Command Group Index (Continued)
Command Group Description Page