Web Management Guide-R05

Table Of Contents
Chapter 2
| Using the Web Interface
Navigating the Web Browser Interface
– 55 –
ARP Inspection 325
Configure General Enables inspection globally, configures validation of additional address
components, and sets the log rate for packet inspection
326
Configure VLAN Enables ARP inspection on specified VLANs 328
Configure Interface Sets the trust mode for ports, and sets the rate
limit for packet inspection
330
Show Information 331
Show Statistics Displays statistics on the inspection process 331
Show Log Shows the inspection log list 332
Administration 335
Log 336
System 336
Configure Global Stores error messages in local memory 336
Show System Logs Shows logged error messages 336
Remote Configures the logging of messages to a remote logging process 338
SMTP Sends an SMTP client message to a participating server 339
LLDP 341
Configure Global Configures global LLDP timing parameters 341
Configure Interface 343
Configure General Sets the message transmission mode; enables SNMP notification; and
sets the LLDP attributes to advertise
343
Add CA-Type Specifies the physical location of the device attached to an interface 347
Show Local Device Information 349
General Displays general information about the local device 349
Port/Trunk Displays information about each interface 349
Show Remote Device Information 353
Port/Trunk Displays information about a remote device connected to a port on this
switch
353
Port/Trunk Details Displays detailed information about a remote device connected to this
switch
353
Show Device Statistics 361
General Displays statistics for all connected remote devices 361
Port/Trunk Displays statistics for remote devices on a selected port or trunk 361
SNMP Simple Network Management Protocol 364
Configure Global Enables SNMP agent status, and sets related trap functions 366
Table 4: Switch Main Menu (Continued)
Menu Description Page