Web Management Guide-R05

Table Of Contents
Chapter 12
| Security Measures
Configuring Port Security
– 300 –
Parameters
These parameters are displayed:
Port – Port identifier.
Security Status – Enables or disables port security on a port.
(Default: Disabled)
Port Status – The operational status:
Secure/Down – Port security is disabled.
Secure/Up – Port security is enabled.
Shutdown – Port is shut down due to a response to a port security violation.
Action – Indicates the action to be taken when a port security violation is
detected:
None: No action should be taken. (This is the default.)
Trap: Send an SNMP trap message.
Shutdown: Disable the port.
Trap and Shutdown: Send an SNMP trap message and disable the port.
Max MAC Count – The maximum number of MAC addresses that can be
learned on a port. (Range: 0 - 1024, where 0 means disabled)
The maximum address count is effective when port security is enabled or
disabled.
Current MAC Count – The number of MAC addresses currently associated with
this interface.
MAC Filter – Shows if MAC address filtering has been set under Security >
Network Access (Configure MAC Filter) as described on page 265.
MAC Filter ID – The identifier for a MAC address filter.
Last Intrusion MAC – The last unauthorized MAC address detected.
Last Time Detected Intrusion MAC – The last time an unauthorized MAC
address was detected.