CLI Reference Guide-R05

Chapter 1 | Initial Switch Configuration
Installing a Port License File
– 54 –
license limits the number of usable ports, whereas a valid license provides full
access to all ports.
Console#show interfaces brief
Interface Name Status PVID Pri Speed/Duplex Type Trunk
--------- --------------- -------- ---- --- ------------- ------------ -----
Eth 1/ 1 Down 1 0 Auto 1000BASE-T None
Eth 1/ 2 License 1 0 Auto 1000BASE-T None
Eth 1/ 3 License 1 0 Auto 1000BASE-T None
Eth 1/ 4 License 1 0 Auto 1000BASE-T None
Eth 1/ 5 License 1 0 Auto 1000BASE-T None
Eth 1/ 6 License 1 0 Auto 1000BASE-T None
:
:
To order a license, you must provide the following information to Edgecore:
◆ Switch model number (for example, ECS2110-26T)
◆ System MAC address. Enter the show system command from the console port
to display this information.
Console#show system
System Description : ECS2110-26T
System OID String : 1.3.6.1.4.1.259.10.1.44.102
System Information
System Up Time : 0 days, 1 hours, 3 minutes, and 14.69 seconds
System Name :
System Location :
System Contact :
MAC Address (Unit 1) : CC-37-AB-BC-4F-FA
Web Server : Enabled
Web Server Port : 80
Web Secure Server : Enabled
Web Secure Server Port : 443
Telnet Server : Enabled
Telnet Server Port : 23
Jumbo Frame : Disabled
System Fan:
Force Fan Speed Full : Disabled
Unit 1
Fan 1: Ok
System Temperature:
Unit 1
Temperature 1: 41 degrees
Unit 1
Main Power Status : Up
Console#
To install a license, first verify that the switch is configured with a valid IP address
(see “Setting an IP Address” on page 42).