CLI Reference Guide-R05

Chapter 11 | Interface Commands
Interface Configuration
– 362 –
history This command configures a periodic sampling of statistics, specifying the sampling
interval and number of samples. Use the no form to remove a named entry from
the sampling table.
Syntax
history name interval buckets
no history name
name - A symbolic name for this entry in the sampling table. (Range: 1-32
characters)
interval - The interval for sampling statistics. (Range: 1-1440 minutes.
buckets - The number of samples to take. (Range: 1-96)
Default Setting
15min - 15 minute interval, 96 buckets
1day - 1 day interval, 7 buckets
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
This example sets a interval of 15 minutes for sampling standard statistical values
on port 1.
Console(config)#interface ethernet 1/1
Console(config-if)#history 15min 15 10
Console(config-if)#
media-type This command forces the transceiver mode to use for SFP+ ports. Use the
no form to restore the default mode.
Syntax
media-type {sfp-forced [mode]}
no media-type
sfp-forced - Forces transceiver mode for the SFP+ port.
mode
1000sfp - Always uses 1000BASE SFP mode.
Default Setting
SFP+ ports: None
Command Mode
Interface Configuration (Ethernet)