CLI Reference Guide-R07

Chapter 20 | VLAN Commands
Editing VLAN Groups
– 478 –
vlan database This command enters VLAN database mode. All commands in this mode will take
effect immediately.
Default Setting
None
Command Mode
Global Configuration
Command Usage
◆ Use the VLAN database command mode to add, change, and delete VLANs.
After finishing configuration changes, you can display the VLAN settings by
entering the show vlan command.
◆ Use the interface vlan command mode to define the port membership mode
and add or remove ports from a VLAN. The results of these commands are
written to the running-configuration file, and you can display this file by
entering the show running-config command.
Example
Console(config)#vlan database
Console(config-vlan)#
Related Commands
show vlan (486)
vlan This command configures a VLAN. Use the no form to restore the default settings or
delete a VLAN.
Syntax
vlan vlan-id [name vlan-name] media ethernet [state {active | suspend}]
[rspan]
no vlan vlan-id [name | state]
vlan-id - VLAN ID, specified as a single number, a range of consecutive
numbers separated by a hyphen, or multiple numbers separated by
commas. (Range: 1-4094)
name - Keyword to be followed by the VLAN name.
vlan-name - ASCII string from 1 to 32 characters.
media ethernet - Ethernet media type.
state - Keyword to be followed by the VLAN state.
active - VLAN is operational.
suspend - VLAN is suspended. Suspended VLANs do not pass packets.