CLI Reference Guide-R07

Chapter 11 | Interface Commands
Transceiver Threshold Configuration
– 375 –
Transceiver Threshold Configuration
transceiver-monitor This command sends a trap when any of the transceiver’s operational values fall
outside of specified thresholds. Use the no form to disable trap messages.
Syntax
transceiver-monitor
Default Setting
Disabled
Command Mode
Interface Configuration (SFP Ports)
Example
Console(config)interface ethernet 1/1
Console(config-if)#transceiver-monitor
Console#
VLAN Membership
Mode
Indicates membership mode as Trunk or Hybrid (page 484).
Ingress Rule Shows if ingress filtering is enabled or disabled (page 483).
Acceptable Frame
Type
Shows if acceptable VLAN frames include all types or tagged frames only
(page 481).
Native VLAN Indicates the default Port VLAN ID (page 485).
Priority for
Untagged Traffic
Indicates the default priority for untagged frames (page 510).
Allowed VLAN Shows the VLANs this interface has joined, where “(u)” indicates untagged and
“(t)” indicates tagged (page 481).
802.1Q-tunnel
Status
Shows if 802.1Q tunnel is enabled on this interface (page 488).
802.1Q-tunnel
Mode
Shows the tunnel mode as Normal, 802.1Q Tunnel or 802.1Q Tunnel Uplink
(page 489).
802.1Q-tunnel TPID Shows the Tag Protocol Identifier used for learning and switching packets
(page 488).
Table 73: show interfaces switchport - display description (Continued)
Field Description