CLI Reference Guide-R07

Chapter 23 | Multicast Filtering Commands
MLD Snooping
– 575 –
show ipv6
mld snooping
This command shows the current MLD Snooping configuration.
Syntax
show ipv6 mld snooping [vlan [vlan-id]]
vlan-id - VLAN ID (1-4094)
Command Mode
Privileged Exec
Command Usage
This command displays global and VLAN-specific MLD snooping configuration
settings.
Example
The following shows MLD Snooping configuration information
Console#show ipv6 mld snooping
Service Status : Disabled
Proxy Reporting : Disabled
Querier Status : Disabled
Robustness : 2
Query Interval : 125 sec
Query Max Response Time : 10 sec
Router Port Expiry Time : 300 sec
Unsolicit Report Interval : 400 sec
Immediate Leave : Disabled on all VLAN
Immediate Leave By Host : Disabled on all VLAN
Unknown Flood Behavior : To Router Port
MLD Snooping Version : Version 2
VLAN Group IPv6 Address Port
---- --------------------------------------- ---------
1 ff05:0:1:2:3:4:5:6 Eth 1/1
Console#show ipv6 mld snooping vlan
VLAN 1
Immediate Leave : Disabled
Unknown Flood Behavior : To Router Port
Console#
show ipv6 mld
snooping group
This command shows known multicast groups, member ports, and the means by
which each group was learned.
Syntax
show ipv6 mld snooping group [X:X:X:X::X | host-ip-addr [interface
interface] | sort-by-port [interface interface] | source-list {X:X:X:X::X | vlan
interface]
X:X:X:X::X - Display the MLD information for the specified MLD group address.
host-ip-addr - Displays the VLANs and Group Host Addresses for the specified
Ethernet port or port-channel.