CLI Reference Guide-R07

Chapter 1 | Initial Switch Configuration
Configuring the Switch for Remote Management
– 49 –
Manual — You have to input the information, including IP address and subnet
mask. If your management station is not in the same IP subnet as the switch, you
will also need to specify the default gateway router. To configure this device as the
default gateway, use the ip default-gateway command.
◆ Dynamic — The switch can send IPv4 configuration requests to BOOTP or
DHCP address allocation servers on the network, or automatically generate a
unique IPv6 host address based on the local subnet address prefix received in
router advertisement messages. An IPv6 link local address for use in a local
network can also be dynamically generated as described in “Obtaining an IPv6
Address” on page 53.
This switch is designed as a router, and therefore does not support DHCP for
IPv6, so an IPv6 global unicast address for use in a network containing more
than one subnet can only be manually configured as described in “Assigning an
IPv6 Address” on page 50.
Manual Configuration
You can manually assign an IP address to the switch. You may also need to specify a
default gateway that resides between this device and management stations that
exist on another network segment. Valid IPv4 addresses consist of four decimal
numbers, 0 to 255, separated by periods. Anything outside this format will not be
accepted by the CLI program.
Note: The default IPv4 address and subnet mask for VLAN 1 is 192.168.2.10
255.255.255.255, with no defined default gateway.
Assigning an IPv4 Address
Before you can assign an IP address to the switch, you must obtain the following
information from your network administrator:
◆ IP address for the switch
◆ Network mask for this network
◆ Default gateway for the network
To assign an IPv4 address to the switch, complete the following steps
1. From the Global Configuration mode prompt, type “interface vlan 1” to access
the interface-configuration mode. Press <Enter>.
2. Type “ip address ip-address netmask,” where “ip-address” is the switch IP
address and “netmask” is the network mask for the network. Press <Enter>.
3. Type “exit” to return to the global configuration mode prompt. Press <Enter>.
4. To set the IP address of the default gateway for the network to which the switch
belongs, type “ip default-gateway gateway,” where “gateway” is the IP address
of the default gateway. Press <Enter>.