CLI Reference Guide-R07

Chapter 2 | Using the Command Line Interface
CLI Command Groups
– 81 –
The access mode shown in the following tables is indicated by these abbreviations:
ACL (Access Control List Configuration)
CM (Class Map Configuration)
GC (Global Configuration)
IC (Interface Configuration)
IPC (IGMP Profile Configuration)
LC (Line Configuration)
MST (Multiple Spanning Tree)
NE (Normal Exec)
PE (Privileged Exec)
PM (Policy Map Configuration)
VC (VLAN Database Configuration)
Address Table Configures the address table for filtering specified addresses,
displays current entries, clears the table, or sets the aging time
435
Spanning Tree Configures Spanning Tree settings for the switch 447
VLANs Configures VLAN settings, and defines port membership for
VLAN groups; also enables or configures private VLANs,
protocol VLANs, voice VLANs, and QinQ tunneling
477
Class of Service Sets port priority for untagged frames, selects strict priority or
weighted round robin, relative weight for each priority queue,
also sets priority for DSCP
507
Quality of Service Configures Differentiated Services 519
Multicast Filtering Configures IGMP multicast filtering, query, profile, and proxy
parameters; specifies ports attached to a multicast router; also
configures multicast VLAN registration, and IPv6 MLD
snooping
531
Link Layer Discovery
Protocol
Configures LLDP settings to enable information discovery
about neighbor devices
593
Domain Name Service Configures DNS services. 617
Dynamic Host
Configuration Protocol
Configures DHCP client and relayfunctions 599
IP Interface Configures IP address for the switch interfaces; also
configures ARP parameters
647
IP Routing Configures static and dynamic unicast routing 685
Debug Displays debugging information for all key functions
These commands are not described in this manual.
Please refer to the prompt messages included in the CLI interface.
Table 6: Command Group Index (Continued)
Command Group Description Page