Web Management Guide-R07

Chapter 12 | Security Measures
Access Control Lists
– 290 –
◆ Source/Destination IP Address Type – Specifies the source or destination
IPv4 address. Use “Any” to include all possible addresses, “Host” to specify a
specific host address in the Address field, or “IP” to specify a range of addresses
with the Address and Mask fields. (Options: Any, Host, IP; Default: Any)
◆ Source/Destination IP Address – Source or destination IP address.
◆ Source/Destination IP Subnet Mask – Subnet mask for source or destination
address. (See the description for Subnet Mask on page 280.)
◆ Source/Destination MAC Address Type – Use “Any” to include all possible
addresses, “Host” to indicate a specific MAC address, or “MAC” to specify an
address range with the Address and Mask fields. (Options: Any, Host, MAC;
Default: Any)
◆ Source/Destination MAC Address – Source or destination MAC address.
◆ Source/Destination MAC Bit Mask – Hexadecimal mask for source or
destination MAC address.
◆ Log – Logs a packet when it matches the access control entry.
Web Interface
To add rules to an ARP ACL:
1. Click Security, ACL.
2. Select Configure ACL from the Step list.
3. Select Add Rule from the Action list.
4. Select ARP from the Type list.
5. Select the name of an ACL from the Name list.
6. Specify the action (i.e., Permit or Deny).
7. Select the packet type (Request, Response, All).
8. Select the address type (Any, Host, or IP).
9. If you select “Host,” enter a specific address (e.g., 11-22-33-44-55-66). If you
select “IP,” enter a base address and a hexadecimal bit mask for an address
range.
10. Enable logging if required.
11. Click Apply.