CLI Reference Guide-R07

Chapter 21 | Class of Service Commands
Priority Commands (Layer 2)
– 511 –
port. (Note that if the output port is an untagged member of the associated
VLAN, these frames are stripped of all VLAN tags prior to transmission.)
Example
The following example shows how to set a default priority on port 3 to 5:
Console(config)#interface ethernet 1/3
Console(config-if)#switchport priority default 5
Console(config-if)#
Related Commands
show interfaces switchport (373)
show queue mode This command shows the current queue mode.
Syntax
show queue mode [interface]
interface
ethernet unit/port (source port)
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10/28)
Command Mode
Privileged Exec
Example
Console#show queue mode
Unit Port queue mode
---- ---- ---------------
1 1 Weighted Round Robin
...
show queue weight This command displays the weights used for the weighted queues.
Syntax
show queue weight [interface]
interface
ethernet unit/port (source port)
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10/28)