CLI Reference Guide-R07

Chapter 13 | Power over Ethernet Commands
– 407 –
■
If sufficient power cannot be made available by turning off power to lower-
priority ports, power may not be supplied to a device connected to a high
or critical priority port.
◆ The priority setting will be ignored if a device is connected to a port after the
switch has finished booting up. When a newly connected device causes the
switch to exceed its budget, power will not be provided to that device’s port
regardless of its priority setting.
■
If priority is not set for any ports, and PoE consumption exceeds the
maximum power provided by the switch, power is shut down in reverse
sequence from port number 8 or 24.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#power inline priority 2
Console(config-if)#
power inline
time-range
This command binds a time-range to a port during which PoE is supplied to the
attached device. Use the no form to remove this binding.
Syntax
power inline time-range time-range-name
no power inline time-range
time-range-name - Name of the time range. (Range: 1-32 characters)
Default Setting
None
Command Mode
Interface Configuration
Example
Console(config)#interface ethernet 1/1
Console(config-if)#power inline time-range rd
Console(config-if)#
Related Commands
time-range (159)
power download Use this command to download an Edgecore compiled firmware file to the
onboard PoE IC.