ECS2020 Series Web Management Guide-R04

45
Step 1: Turn off the IGMP and MLD functions.
Step 2: Enable the Management VLAN. (Confirm that the switch management IP address is in the same segment as
the IP cameras and NVRs.)
Step 3: Configure the ONVIF VLAN ID.
Step 4: Configure the port number used by the ONVIF protocol. The default is 554.
Step 5: Set the ONVIF Global State to “ON.”
Step 6: Click "Apply".
5.4.2 View IP-Camera Information
Click on the navigation bar "VLAN Management" "ONVIF" "IP-Camera Information" to view the information:
Figure 5-20: IP-Camera Information
5.4.3 View NVR Information
Click on the navigation bar "VLAN Management" "ONVIF" "NVR Information" to view the information:
Figure 5-21: NVR Information