ECS2020 Series CLI Reference Guide-R04

60
The voice-vlan default mode is autoTag
Interface configuration mode
If the port voice VLAN mode is set to autoTag, the port is set to add tags of the Voice
VLAN. If the mode is autountag, the port will not add tags to any traffic. Note: when setting
the voice VLAN mode to manual, the port must be forwarded to the voice VLAN in
advance
Configure port 1 to join voice VLAN as autotag
ECS2020-10P(config)# interface GigabitEthernet 0/1
ECS2020-10P(config-if-GigabitEthernet0/1)# voice-vlan mode autoTag
voice VLAN OUI
In global configuration mode, set the OUI-table and note that the MAC address cannot be either
multicast or broadcast addresses and further the mask used cannot have a zero before an F.
voice-vlan oui-table A:B:C:D:E:F mask A:B:C:D:E:F
The voice-vlan oui-table defaults to 8 matching rules.
Global configuration mode
In global settings, the oui-table adds the port to the voice VLAN when the port's source
MAC address matches the address in the oui list
Configure voice VLAN OUI
ECS2020-10P(config)# voice-vlan oui-table 02:00:12:32:56:89 mask FF:FF:FF:FF:FF:00
Command
Command
Description
show voice-vlan
Display configuration of voice-vlan
information
Parameter
Parameter
Description
voice-vlan oui-table
Matches the filter's source MAC address for
an incoming message
Command
Command
Description
show voice-vlan interfaces GigabitEthernet
0/1
Displays the configuration of the
voice-vlan oui-table.
Default
Mode
Usage
Example
Default
Mode
Usage
Example