ECS2020 Series CLI Reference Guide-R04

234
Show fiber-transceiver
Use this command to view the fiber port transceiver signal information such as temperature,
voltage, power etc…
This command is only available through the CLI command interface.
show fiber-transceiver interfaces GigabitEthernet port-id
parameter
Default None
Mode Privilege configuration mode
Usage
Use this command to view the fiber port transceiver signal information.
Example ECS2020-10T# show fiber-transceiver interfaces gig 0/9
Port | Temperature | Voltage | Current | Output power | Input power |
OE-Present | LOS
| [C] | [Volt] | [mA] | [mWatt] | [mWatt]
| |
=================================================================
===================
gi0/9 | 41.15 (OK) | 3.33 (OK) | 20.50 (OK) | 0.32 (OK) | 0.00 (E)
| Insert | Loss
Temp - Internally measured transceiver temperature
Voltage - Internally measured supply voltage
Current - Measured TX bias current
Output Power - Measured TX output power in milliWatts
Input Power - Measured RX received power in milliWatts
OE-Present - SFP Presetn or Not Present
LOS - Loss of signal
N/A - Not Available, N/S - Not Supported, W - Warning, E - Error
Parameter
Description
port-id
The fiber port selection.