ECS2020 Series CLI Reference Guide-R04

197
No TLV selected
Interface configuration mode
Use the “lldp tlv-select” command to attach selected TLV to LLDP PDU. The
configuration can be viewed using the “show lldp” command. Use the no form
of this command to remove all selected TLV. This example selects the system
description TLV and then set the TLV selected to default.
ECS2020-10P(config-if-GigabitEthernet0/1)# lldp tlv-select sys-
desc
ECS2020-10P(config-if-GigabitEthernet0/1)# no lldp tlv-select
lldp tlv-select pvid
Use this command to configure whether to attach or not the LLDP 802.1 PVID TLV. Use the no form of
the command to set the attach state to default.
lldp tlv-select pvid (disable|enable)
no lldp tlv-select pvid
Parameter
Parameter
Description
TLV
Select from the following optional LLDP optional TLV:
port-desc, sys-name, sys-desc, sys-cap, mac-
phy, lag, max-frame-size, or management-addr.
Command
Command
Description
show lldp interfaces GigabitEthernet 0/1
Displays the LLDP information.
Parameter
Parameter
Description
disable
Disable the LLDP 802.1pvid tlv attach state
enable
Enable the LLDP 802.1pvid tlv attach state
Default
Mode
Usage
Example