ECS2020 Series CLI Reference Guide-R04

196
lldp med tlv-select
Use this command to configure the selected MED TLVs for LLDP packets.
lldp med tlv-select MEDTLV [MEDTLV] [MEDTLV] [MEDTLV]
no lldp med tlv-select
network-policy TLV
Interface configuration mode
Use the “lldp med tlv-select” command to configure the LLDP MED TLV
selection. Note that even if no MED TLV is selected, the MED capable TLV
will be attached if LLDP MED is enabled. The configuration
can be viewed by using the “show lldp med” command. Use the no form of
this command to remove all selected MED TLV over the dedicated ports.
ECS2020-10P(config-if-GigabitEthernet0/1)# lldp med tlv-select
network-policy
ECS2020-10P(config-if-GigabitEthernet0/1)# no lldp med tlv-s
elect
lldp tlv-select
Use this command to select TLVs from the optional list shown below. Use the no form of the
command to set the TLV selected to default.
lldp tlv-select TLV [TLV] [TLV] [TLV] [TLV] [TLV] [TLV] [TLV]
no lldp tlv-select
Parameter
Parameter
Description
MEDTLV
MED optional TLV. Available optional TLVs are
network-policy, location, poe-pse, and inventory.
Command
Command
Description
show lldp interfaces GigabitEthernet 0/1
Display LLDP information
Default
Mode
Usage
Example