ECS2020 Series CLI Reference Guide-R04

194
Global configuration mode
Use the “lldp lldpdu” command to configure the LLDP PDU handling behavior when
LLDP is globally disabled. Note that if LLDP is globally enabled and per port
LLDP receive status is configured to disabled, the received LLDP PDU would be
dropped instead of using the global disable behavior. The configuration can be
displayed by using the “show lldp” command.
ECS2020-10P(config)# lldp lldpdu bridging
LLDP med
LLDP module re-initialization delay.
This command is only available through the CLI command interface.
lldp med
no lldp med
lldp med
Interface configuration mode
Use “lldp med” to configure the LLDP MED enable status. If LLDP MED is enabled, the
LLDP MED capability TLV and other selected MED TLV will be attached. The
configuration can be shown by using the “show lldp med” command. Use the no form of
this command to restore the behavior to default.
ECS2020-10P(config-if-GigabitEthernet0/1)# lldp med
ECS2020-10P(config-if-GigabitEthernet0/1)# no lldp med
Command
Command
Description
show lldp
Displays the LLDP information.
Parameter
Parameter
Description
Null
Null
Usage
Example
Default
Mode
Usage
Example
Mode