ECS2020 Series CLI Reference Guide-R04

192
LLDP reinit-delay
Use this command to set the LLDP module re-initialization delay. Use the no form of the command
to remove any delay.
lldp reinit-delay <1-10>
no lldp reinit-delay
2s
Global configuration mode
Use the “lldp reinit-delay” command to configure the LLDP reinit-delay. The delay
avoids LLDP generating too many PDUs if the port status toggles up and dow
frequently. Thedelay starts to count when the port links status changes to down
delaying sending any new LLDP pdu until the delay counts to zero . The
configuration is displayed by using the “show lldp” command. Use the no form
of this command to disable the LLDP reinit delay.
ECS2020-10P(config)# lldp reinit-delay 5
ECS2020-10P(config)# no lldp reinit-delay
LLDP holdtime-multiplier
Use this command to set the LDDP holdtime-multiplier. Use the no form of the command to remove
it.
lldp holdtime-multiplier <2-10>
no holdtime-multiplier
Parameter
Parameter
Description
<1-10>
Specifies the LLDP re-initial delay time in
seconds.
Command
Command
Description
show lldp
Displays the LLDP information.
Default
Mode
Usage
Example