ECS2020 Series CLI Reference Guide-R04

16
Global configuration mode
You can configure manual mode and lacp mode. The no command removes all
interfaces from the aggregation group.
The following example creates a link aggregation group 1
ECS2020-10P(config)#link-aggregation 1 mode manual
Interface link-aggreation
Sets a physical port as a member port of a link-aggregation group. Use the no option of the command to
remove the link-aggregation port member from the group.
link-aggregation group-number [active| passive|manual]
no link-aggregation
{
group-number}
The physical port does not belong to any link-aggregation group.
Interface configuration mode
All AGG member interfaces need to be in the same VLAN.
ECS2020-10P(config)# interface GigabitEthernet /1
ECS2020-10P(config-if-GigabitEthernet0/1)# link-aggregation 1 active
2.2 Display relevant commands
show link-aggregation
Display link-aggregation settings.
show link-aggregation [group|group-number ]
Null
Parameter
Parameter
Description
group-number
The link-aggregation port group number
Command
Command
Description
show link-aggregation group
Display the information of the link aggregation group
parameter
Parameter
Description
show link-aggregation group
Show all link aggregation groups
show link-aggregation group group-number
Displays a specific link
aggregation group
Default
Mode
Usage
Mode
Usage
Example
Example
Default