ECS2020 Series CLI Reference Guide-R04

127
Enabled
Global configuration
Use the ipv6 mld snooping vlan mrouter learn pim-dvmrp command to enable
learning router port by routing protocol packets such as PIM/PIMv2,DVMRP or MOSPF.
Use the no form of this command to disable it.
You can verify the settings by using the show ipv6 mld snooping vlan command.
The following example specifies to
enable learning router port
function pim-
dvmrp on VLAN2：
ECS2020-10P(config)# ipv6 mld snooping vlan 2 mrouter learn pim-dvmrp
ipv6 mld snooping vlan static-group
Use this command to add a static group to a VLAN with mld snooping enabled.
ipv6 mld snooping vlan VLAN-LIST static-group group-address interfaces
GigabitEthernet|Aggregateport IF_PORTS
no ipv6 mld snooping vlan VLAN-LIST static-group group-address interfaces
GigabitEthernet|Aggregateport IF_PORTS
No static groups set.
Global configuration
Use the ipv6 mld snooping vlan static-group command to add a static group. The static
group will not learn other dynamic ports. If a dynamic group exists, then the static group
will overlap the dynamic group.The static group is set to valid unless mld snooping vlan is
enabled.
Use the no form of this command to delete a static group. When removing the last member
of a static group, the static group will be deleted.
You can verify settings by using the show ipv6 mld snooping groups command.
Command
command
description
Show ipv6 mld snooping vlan
Verify the ipv6 mld snooping information.
Parameter
parameter
description
Ip-addr
Specifies a multicast group ipv6 address.
IF-PORTS
Specifies a port list to set or remove.
Default
Mode
Default
Mode
Usage
Usage
Example