ECS2020 Series CLI Reference Guide-R04

115
None.
Port configuration
Use the ip igmp filter command to bind a profile to a port. When a port is binded to a
profile the port learning group will update, if the group does not match the profile rule it
will remove the port from the group. Static groups are excluded.
Use the no form of this command to delete a profile.
You can verify settings by using the show running-config command.
The following example specifies that set ip igmp filter test.
ECS2020-10P(config)# interface GigabitEthernet 0/1
ECS2020-10P(config-if-GigabitEthernet0/1)# ip igmp filter 1
26.2 Commands related to display and monitoring
clear ip igmp snooping statistics
Use this command to clear the igmp snooping statistics.
clear ip igmp snooping statistics
Null
Privileged EXEC
This command will clear all of the igmp packet statistics.
You can verify the statistics were cleared by using the show ip igmp snooping statistics
command.
Command
Command
Description
Show running-config
Check the ip igmp filter profile information
Parameter
Parameter
Description
None
Clears all igmp packets statistics.
Default
Mode
Usage
Default
Mode
Usage
Example