ECS2020 Series CLI Reference Guide-R04

108
No ip igmp snooping querier by default.
Global configuration
When enabling an ip igmp vlan querier, there will be a router selected, the selection
success will end general and specific queries.
Use the ip igmp snooping vlan querier command to add a querier.
Use the no form of this command to delete a querier.
You can verify settings by the show ip igmp snooping querier command.
The following example specifies to enable a vlan querier test：
ECS2020-10P(config)#
ip igmp snooping vlan 2 querier
ip igmp snooping vlan querier version
Use this command to set the igmp snooping querier version in global configuration mode.
ip igmp snooping vlan VLAN-LIST querier version (2|3)
The default querier verion is 2.
Global configuration
Use the ip igmp snooping vlan querier version command to set querier version.
You can verify settings by using the show ip igmp snooping querier command.
Parameter
Parameter
Description
VLAN-LIST
Specifies VLAN ID list to set
Command
Command
Description
Show ip igmp snooping querier
Display the IGMP snooping settings.
Parameter
Parameter
Description
VLAN-LINST
Specifies VLAN ID list to set
(2|3)
Query version 2 or 3
Default
Mode
Usage
Example
Default
Mode
Usage