ECS2020 Series CLI Reference Guide R04

63
18 Surveillance VLAN
18.1 Configure commands
surveillance VLAN
First create a VLAN, and when creating a surveillance VLAN specify the VLAN created to enable a
surveillance VLAN ID. Use the “no” command to remove a surveillance VLAN. Surveillance VLANs
are disabled by default.
surveillance-vlan vlan id surveillance-vlan
no surveillance-vlan
Null
Global configuration mode
Use show surveillance-vlan to view the configure of surveillance-vlan
ECS2020-10P(config)# surveillance-vlan vlan
3 ECS2020-10P(config)# surveillance-vlan
surveillance-vlan mode
Using this command specifies a two - layer interface (switch port) mode, which can be
specified as either auto or manual for a switch port . Use the surveillance-vlan mode auto
option to revert the schema of the interface to default values. Ports can not configure a
surveillance-vlan on an access port.
surveillance-vlan mode [auto| manual]
Parameter
Parameter
Description
auto
Sets the surveillance VLAN mode for a port to
autoTag
manual
Sets the surveillance VLAN mode for a port to
manual
Parameter
Parameter
Description
surveillance-vlan vlan id
The number of surveillance-vlan id, note that the
surveillance vlan ID can not be same as voice vlan ID
Command
Command
Description
show surveillance-vlan
View global configuration of a
surveillance VLAN
Example
Default
Mode
Usage