ECS2020 Series CLI Reference Guide R04

Command
195
lldp med fast-start-repeat-count
Use this command to configure LLDP MED fast start repeat count.
lldp med f ast-start-repeat-count <1-10 >
no lldp med fast-start-repeat-count
3
Global Configuration
Use the “lldp lldp med fast-start-repeat-countcommand to configure LLDP
bpdu fast start tx repeat. When a port link goes down, it will send an LLDP PDU
immediately to notify a link partner, the number of LLDP PDU sent depends on
the fast-start-repeat-count configuration. The LLDP PDU fast-start transmits in
an interval of one second. The fast start behavior works whether LLDP MED is
enabled or
not. The configuration could be shown by using the command
“show lldp med”. Use the no form of this command to restore the behavior to
default.
ECS2020-10P(config)# lldp med fast-start-repeat-count 3
Command
Description
show lldp
Display lldp information
Parameter
Description
<1-10>
LLDP PDU fast start TX repeat counts.
Command
Command
Description
show lldp med
Displays the LLDP MED information.
Default
Mode
Usage
Example