ECS2020 Series CLI Reference Guide R04
16
Global configuration mode
You can configure manual mode and lacp mode. The no command removes all
interfaces from the aggregation group.
The following example creates a link aggregation group 1
ECS2020-10P(config)#link-aggregation 1 mode manual
Interface link-aggreation
Sets a physical port as a member port of a link-aggregation group. Use the no option of the command to
remove the link-aggregation port member from the group.
link-aggregation group-number [active| passive|manual]
no link-aggregation
{
group-number}
The physical port does not belong to any link-aggregation group.
Interface configuration mode
All AGG member interfaces need to be in the same VLAN.
ECS2020-10P(config)# interface GigabitEthernet /1
ECS2020-10P(config-if-GigabitEthernet0/1)# link-aggregation 1 active
2.2
Display relevant commands
show link-aggregation
Display link-aggregation settings.
show link-aggregation [group|group-number ]
Null
Parameter
Parameter
Description
group-number
The link-aggregation port group number
Command
Command
Description
show link-aggregation group
Display the information of the link aggregation group
parameter
Parameter
Description
show link-aggregation group
Show all link aggregation groups
show link-aggregation group group-number
Displays a specific link
aggregation group
Default
Mode
Usage
Mode
Usage
Example
Example
Default