ECS2020 V1.0.2.11 SWR Release Note

ENGINEERING RELEASE NOTES
6/2000 P/N: 9038023-04 Subject to Change Without Notice
Page: 15 of 6
F0615-E
Management >> Configuration Management ..點選 [ SAVE ] ,才算是真正
的存檔。功能設定的 ( save ) 代表的應該是 APPLY . 防止客戶搞混,是否應該修
改成( Apply 或是 OK .. Apply -->中文 (套用 ) Save-->英文(存 )
18
ECS2020-08_026
STP port fast - network mode , what is network mode?
19
ECS2020-08_028
STP trap, STP trap port count start form '0', EX: port #1 Topology Change,
but trap content is "port 0 change..."
20
ECS2020-08_029
LLDP PDU flooding enabled prevents executing mSTP enable.
21
ECS2020-08_030
MSTP , can't disable LLDP PDU flooding in WEB
22
ECS2020-08_031
STP BPDU guard , does not support auto recovery
23
ECS2020-08_032
STP BPDU guard, there is no link down reaseon and log message?
24
ECS2020-08_036
port link down/up when enable/disable EEE
25
ECS2020-08_042
Question: what is port mode "access", "hybrid" and "trunk"? No
information in MG
26
ECS2020-08_043
can't modify static ip address if none of IPv6 gatway address. But none of
IPv6 gatway address by default
27
ECS2020-08_044
have to enable DHCP snooping first before change management IP (DHCP)
28
ECS2020-08_047
QoS 請用 Cos 取代 Priority
29
ECS2020-08_048
ECS2020-10P# show qos map dscp-queue
DSCP to Queue mappings 內容有問
30
ECS2020-08_049
ECS2020-10P# show qos map precedence-queue 問題.應該只有 QoS1-4
不是 1-8 的數據
31
ECS2020-08_050
no MAC counter ?
can't clear mac table on WEB GUI
can't configure aging-time on WEB GUI
32
ECS2020-08_051
QoS web 畫面, 802.1p 旁邊增加這些敘述
( If you want to see more detail QoS status. Please go to CLI manual and
check the detail)
33
ECS2020-08_063
maximum pps is 4000!? (MTN 建議值)
Cpu Port Bandwidth (64-4000): pps
Cpu Protect Manage Bandwidth (1-4000): pps
Cpu Protect Route Bandwidth (1-4000): pps
Cpu Protect Protocol Bandwidth (1-4000): pps
( list)
34
ECS2020-08_064
EC 改成(ACL permit any any (default)
35
ECS2020-08_065
IPv4 standard ACL : 10 ACL(0-9) , 10ACE per ACL , Wildcards mask?