ECS2020 Series CLI Reference Guide R04

59
17 Voice VLAN
17.1 Configure commands
voice VLAN
Create a VLAN first and then specify the VLAN when creating a Voice VLAN for voice traffic using
the VLAN ID. Use the “no” command to close voice VLAN .Voice VLAN is disable by default.
voice-vlan vlan id voice-vlan
no voice-vlan
Null
Global configuration mode
Use show voice-vlan to view the voice-vlan configuration.
ECS2020-10P(config)# voice-vlan vlan 2
ECS2020-10P(config)# voice-vlan
voice-vlan mode
Using this command specifies a two - layer interface (switch port) mode, which can be specified as
autotag, autountag or manual for a switch port . Use the voice-vlan mode autounTag option to revert
the schema of the interface to default values. Note that ports can not configure a voice-vlan on an
access port.
Voice-vlan mode [autoTag | autounTag | manual ]
Parameter
Parameter
Description
voice-vlan vlan id
The identifier of the voice-vlan/ Note that the voice
vlan ID can not be same as a surveillance vlan ID
Command
Command
Description
show voice-vlan
View the voilce VLAN global
configuration VLAN。
Parameter
Parameter
Description
autoTag
Auto tagging is voice VLAN default mode
autounTag
Voice VLAN untagged mode.
manual
Manual tagged voice vlan mode
Default
Mode
Usage
Example