ECS2020 Series CLI Reference Guide R04

198
Enabled
Interface configuration mode
Use the “lldp tlv-select pvid” command to configure the 802.1 PVID TLV
attached enable status. The configuration can be viewed using the “show
lldp” command.
ECS2020-10P(config-if-GigabitEthernet0/1)# lldp tlv-select pvid
enable
ECS2020-10P(config-if-GigabitEthernet0/1)# lldp tlv-select pvid
disable
lldp tlv-select vlan-name
Use this command to configure whether to attach or not the LLDP VLAN name TLV. Use the no form
of the command to set the attach state to default.
lldp tlv-select vlan-name add (add|remove) vlan-list
no lldp tlv-select
no VLAN attached.
Command
Command
Description
show lldp interfaces GigabitEthernet 0/1
Displays the LLDP information.
Parameter
Parameter
Description
VLAN-LIST
VLAN List (e.g. 3,6-8): The range of VLAN ID is 2
to 4094
Default
Mode
Usage
Example
Default