ECS2020 Series CLI Reference Guide R04

191
default is disable
Interface configuration mode
Use the “lldp rx” command to enable the LLDP PDU RX ability. The configuration is
displayed by using the “show lldp” command.
ECS2020-10P(config-if-GigabitEthernet0/1)# lldp rx
ECS2020-10P(config-if-GigabitEthernet0/1)# no lldp rx
LLDP tx-interval
Use this command to set the LLDP message transmission interval.
lldp tx-interval <5-32767> no
lldp tx-interval
30s
Global configuration mode
Use “lldp tx-interval” command to set the LLDP TX interval. It should be
noted that both ”lldp tx-interval ” and ”lldp tx-delay” affects the lldp pdu tx
time, the larger value of the two configuration decides the TX interval, the configuration
is viewed by using the “show lldp” command.
ECS2020-10P(config)# lldp tx-interval 10
ECS2020-10P(config)# no lldp tx-interval
Command
Command
Description
show lldp
Display LLDP information
Parameter
Parameter
Description
<5-32767>
Specify the LLDP PDU tx interval in unit of
second
Command
Command
Description
show lldp
Displays the LLDP information.
Default
Mode
Usage
Example
Default
Mode
Usage
Example