ECS2020 Series CLI Reference Guide R04

186
If this function is enabled and the switch reboots or restarts, a trap message is
sent after a successful reboot.
Global configuration mode
For either warm-start and cold-starts a trap function can be enabled. After a successful
restart the relevant trap message will be sent if enabled.
ECS2020-10P(config)# snmp trap cold-start
ECS2020-10P(config)# snmp trap warm-start
snmp trap stp
Use this command to enable sending an STP trap after a topology change or a new root bridge is
created. Use the no option of this command and SNMP will not send an STP trap.
snmp trap stp
no snmp trap stp
Disabled
Global configuration mode.
When a network topology change is detected or a new root bridge is created, an
STP Trap is sent if enabled otherwise none is sent.
ECS2020-10P(config)# snmp trap stp
ECS2020-10P(config)# no snmp trap stp
Command
Command
Description
show snmp trap
Views the snmp trap configuration.
parameter
Parameter
Description
Null
Null
Default
Mode
Usage
Example
Default
Mode
Usage
Example