ECS2020 Series CLI Reference Guide R04

185
snmp trap link-status
Use this command to enable sending a link-status trap (LinkTrap) should a port link status
change. Use the no option of this command and SNMP will not send LinkTrap.
snmp trap linkup
snmp trap linkDown
When this function is enabled and the link status of a port changes, SNMP will send a
LinkTrap.
Global configuration mode.
For an interface (Ethernet interface, Ap interface or SVI interface), this command
configures whether to send an interface LinkTrap or not. If an interface changes Link
state, SNMP will issue a LinkTrap.
ECS2020-10P(config)# snmp trap linkUp
ECS2020-10P(config)# snmp trap linkDown
snmp trap restart
Use this command to enable sending a warm-start or cold-start trap after a successful restart. Use
the no option of this command and SNMP will not send a warm or cold start trap.
snmp trap cold-start
snmp trap warm-start
parameter
Parameter
Description
Null
Null
Command
Command
Description
show snmp trap
Views the snmp trap configuration.
parameter
Parameter
Description
Null
Null
Default
Mode
Usage
Example