ECS2020 Series CLI Reference Guide R04

200
ECS2020-10P(config-if-GigabitEthernet0/1)# lldp tx
ECS2020-10P(config-if-GigabitEthernet0/1)# no lldp tx
LLDP tx-delay
Use this command to specify a delay in seconds between successive LLDP transmissions.
Use the no form of the command to set the delay to the default value.
lldp tx
no lldp tx
2s
Global Configuration
Use the “lldp tx-delay” command to configure the delay in seconds between
successive LLDP frame transmissions. The delay starts to count when any
LLDP PDU is sent such as an LLDP PDU advertise routine, LLDP PDU
content change, port link up, etc... The configuration can be viewing by using
the “show lldp” command. Use the no form of this command to restore the
delay to default value.
ECS2020-10P(config)# lldp tx-delay 5
ECS2020-10P(config)# no lldp tx-delay
Usage
Use the “lldp tx” command to enable the LLDP PDU TX ability. The
configuration can be viewed using the “show lldp” command.
Command
Command
Description
show lldp
Displays the LLDP information
Parameter
Parameter
Description
<1-8192>
Specifies the LLDP transmission delay in unit of
seconds.
Example
Default
Mode
Usage
Example