ECIS4500 series Web Management Guide R02

Command Descriptions
131
Snooping.
It is suggested to enable Unregistered Flooding control when the MVR group table is
full.
Delete
Check to delete the entry. The designated entry will be deleted during the next save.
MVR VID
Specify the Multicast VLAN ID.
Be Caution: MVR source ports are not recommended to be overlapped with
management VLAN ports.
MVR Name
MVR Name is an optional attribute to indicate the name of the specific MVR VLAN.
Maximum length of the MVR VLAN Name string is 16. MVR VLAN Name can only
contain alphabets or numbers. When the optional MVR VLAN name is given, it should
contain at least one alphabet. MVR VLAN name can be edited for the existing MVR
VLAN entries or it can be added to the new entries.
IGMP Address
Define the IPv4 address as source address used in IP header for IGMP control
frames.
The default IGMP address is not set (0.0.0.0).
When the IGMP address is not set, system uses IPv4 management address of the IP
interface associated with this VLAN.
When the IPv4 management address is not set, system uses the first available IPv4
management address.
Otherwise, system uses a pre-defined value. By default, this value will be
192.168.2.10.
Mode
Specify the MVR mode of operation. In Dynamic mode, MVR allows dynamic MVR
membership reports on source ports. In Compatible mode, MVR membership reports
are forbidden on source ports. The default is Dynamic mode.
Tagging
Specify whether the traversed IGMP/MLD control frames will be sent as Untagged or
Tagged with MVR VID. The default is Tagged.
Priority
Specify how the traversed IGMP/MLD control frames will be sent in prioritized
manner. The default Priority is 0.
LLQI
Define the maximum time to wait for IGMP/MLD report memberships on a receiver
port before removing the port from multicast group membership. The value is in units
of tenths of a seconds. The range is from 0 to 31744. The default LLQI is 5 tenths or
one-half second.
Interface Channel Profile
When the MVR VLAN is created, select the IPMC Profile as the channel filtering
condition for the specific MVR VLAN. Summary about the Interface Channel Profiling
(of the MVR VLAN) will be shown by clicking the view button. Profile selected for
designated interface channel is not allowed to have overlapped permit group address.
Profile Management
You can inspect the rules of the designated profile by using the following button: