ECIS4500 Series CLI Reference Guide R02

13
3.2 Enable Mode Commands
All the “show - -” commands in this section can also be executed under any other command
mode except Initialize Mode.
3.2.1 configure terminal
Description
Enter configuration mode.
Syntax
configure
Parameter
None
3.2.2 disable
Description
Enter init mode.
Syntax
disable
Parameter
None
3.2.3 show aaa
Description
Show AAA
Syntax
show aaa
Parameter
None
3.2.4 show access management
Description
Access management configuration
Syntax
show access management [ statistics | <access_id_list> ]
Parameter
Name
Description
statistics
Statistics data
access_id_list
ID of access management entry
3.2.5 show access-list
Description
Access list
Syntax
show access-list [ interface [ ( <port_type> [ <v_port_type_list> ] ) ] ]
[ rate-limiter [ <rate_limiter_list> ] ] [ ace statistics [ <ace_list> ] ]
show access-list ace-status [ static ] [ link-oam ] [ loop-protect ] [ dhcp ]
[ ptp ] [ upnp ] [ arp-inspection ] [ mep ] [ ipmc ] [ ip-source-guard ]
[ ip-mgmt ] [ conflicts ] [ switch <switch_list> ]
Parameter
Name
Description
interface
Select an interface to configure
ace-status
The local ACEs status
port_type
GigabitEthernet,1 Gigabit Ethernet Port
v_port_type_list
PORT_LIST, Port list in 1/1-14
rate-limiter
Rate limiter
rate_limiter_list
<RateLimiterList : 1~16> Rate limiter ID
ace
Access list entry
statistics
Traffic statistics
ace_list
<AceId : 1~256> ACE ID
static
The ACEs that are configured by users manually
loop-protect
The ACEs that are configured by Loop Protect
module
ipmc
The ACEs that are configured by IPMC module
ip-source-guard
The ACEs that are configured by IP Source Guard
module